Anyone who’s worked on electronics know the frustration of the “easy to insert, hard as hell to remove” type fasteners that manufacturers insist on using. Basically the exact same principle as this. Plenty of plastic casing fasteners and super tiny and delicate connectors are built like that. If something goes wrong during disassembly, at best you’ll have an unsightly crack or blemish on the casing, at worst you rip an internal connector and its socket right off the circuit board along with some traces, destroying it. And getting frustrated exponentially increases the chances you’ll break something.
“I’ll just pop off this U.FL antenna connector…and its socket too I guess…”
I’ve accidentally peeled like an inch of copper traces off the PCB too, when the pads are attached strongly enough (or the copper is adhered weakly enough? Not sure which). Way worse feeling than nails on a chalkboard, RIP device.
Ok real talk here for a minute. If, by any chance, some dufus has put a lightbulb in their month and need help removing it, grab a sturdy cloth towel, pass it into their mouth through the corners and gently wrap the glass part of the lightbulb in the cloth. When you’re done, all corners of the cloth should be hanging outside persons mouth. Their teeth should not touch the glass directly - only through the cloth. This way when the glass breaks, all the pieces will be contained I the cloth for an easy and, if you are careful, harmless removal.
The safest way to crack the bulb once you’ve wrapped it in cloth is to GENTLY tap the bottom jaw - imagine a 4 year-old landing an uppercut. The glass is very thin and cracks easily, - no need for much force.
Of course, better not get into such a situation in the first place. Stay safe, folks!
You can also like, dislocate your jaw. That works. Would not recommend doing unless you can already dislocate it on command though.
That is oddly specific knowledge.
Healthcare
I want to make a food (maybe chocolate) the exact dimensions of of a lightbulb so I can try this safely. I really think I could take it out.
There’s LED bulbs of the exact size and shape but with plastic casings
But then if it gets stuck you can’t even break it, you’d just have to live like that.
LED bulbs are low risk. I’m gonna do it.
How’d it go?
It was enlightening. Like I got my lips around the base. I pulled it out just fine. Maybe these folks were like deep throating these light bulbs, which honestly I think the porn industry might have influenced these light bulb deep throats.
I don’t understand why this is so tempting. It’s clearly dangerous and even says not to do it.
Anyways, my mouth is ever slightly too small for one to accidentally slip in. But I could probably force it and not have the ability to crunch a plastic LED bulb to get it out.
This bulb is my bulb it was made for me!
It’s tempting because it sounds like complete and utter bullshit and we think we could prove it wrong.
I mean, I’m not going to actually stick a lightbulb in my mouth, but I’m still convinced it’s bullshit.
I hate this so much. This is worse than The Game
